Double Tee Bed Preparation Machine Concrete Placement Machine Cleaning and Oiling Carts
Designed and built to remove and place bulkheads, clean and apply release agent on deck and stems and pull all required strands in one pass following stripping process. Not only dramatically reduces labour but allows for stressing immediately following stripping process. Designed and built to distribute and screed concrete along Panel or Double Tee casting bed. Designed to hold up to 6 yards of concrete, will accurately meter traditional or self-compacting concrete mix. Multiple gates limit concrete discharge to specific area along bed width while the metering wheel controls the rate of concrete flow. Incorporated vibrating screed can be used to screed top and bottom layer of concrete if used in insulated wall panel production. Distributes non-insulated and insulated tarps along your casting bed. Self-powered, with optional tarp hoop rack and strand pulling arm. Use with Bonnybrook Tarps to improve curing performance. Designed and built to strip, turn and place in final location precast median barriers cast in Bonnybrook dual cavity forms. Operated by one person with remote controller and self-powered with integrated gas engine. Designed to be used suspended from overhead crane. Designed and built to form ribs on outside surface of insulated wall panels. High variety of deep rib patterns with optional rollers. Quality of ribs cannot be matched by those formed using liners or sled system. With optional attachments can perform cleaning and oiling of casting bed and pull all required strands. If smooth roller is used, floating top finish can be achieved; optional vibrating screed can be also used for a flat finish. Designed and built for piles and turnout railroad ties. Will distribute concrete and form top surface of concrete product to streamline production. Self-powered, will travel along your single or multiple-cavity bed, and clean and apply release agent.
Double Tee Bed Preparation Machine
Designed and built to remove and place bulkheads, clean and apply release agent on deck and stems and pull all required strands in one pass following stripping process. Not only dramatically reduces labour but allows for stressing immediately following stripping process.
|
